Trendy News Flash: How To Adjust The Temperature Of An Electric Hot Water Heater

Adjusting the temperature of an electric hot water heater is a straightforward process, but it's important to ensure the correct settings to balance safety and energy efficiency. Here's a step-by-step guide on how to adjust the temperature of your electric hot water heater:

1. Turn Off the Power

Before adjusting the temperature, make sure to turn off the power to the water heater. This is a crucial safety step to avoid electrical shocks.

Locate the circuit breaker in your electrical panel that controls the water heater and switch it off.

2. Access the Thermostat

Electric water heaters typically have two thermostats—one for the upper heating element and one for the lower heating element. Both thermostats need to be adjusted to ensure consistent water temperature.

Locate the access panels: These are usually small panels on the side of the water heater. You may need a screwdriver to remove the screws.
Remove the insulation: Under the access panel, you will find insulation that needs to be pulled back to reveal the thermostat.

3. Adjust the Thermostat

Once the thermostat is visible, you can adjust the temperature using a flathead screwdriver.

Temperature setting: The thermostat typically has a dial with temperature markings or a simple "hot/warm" indicator. For most households, a temperature setting of 120°F (49°C) is recommended for efficiency and safety. This prevents scalding while saving energy.
Turn the dial to the desired temperature setting for both the upper and lower thermostats if applicable.

4. Replace the Insulation and Panels

After adjusting the thermostat(s):

Replace the insulation to cover the thermostat and heating elements. This helps retain heat and ensures the heater operates efficiently.
Reattach the access panels using the screws you removed earlier.

5. Turn the Power Back On

Once everything is secured, go back to your circuit breaker and turn the power back on to the water heater.

6. Wait for the Water to Heat

It may take a few hours for the water to reach the newly set temperature, depending on the size of your water heater and the previous setting.

7. Test the Water Temperature

After the water has had time to heat, check the temperature by running hot water from a faucet. You can use a thermometer to ensure it's at the desired setting (120°F or your preferred temperature).

Safety Tips:

Avoid setting the temperature above 120°F: Higher temperatures increase the risk of scalding, especially for children and the elderly. It also raises energy consumption.
Regularly check the temperature: Over time, thermostats can become inaccurate. Regular checks can ensure consistent water temperatures.
Check for leaks: After adjusting the temperature, ensure there are no leaks from the access panel or other parts of the water heater.

By following these steps, you can adjust the temperature of your electric hot water heater safely and efficiently.

Hot Water Solutions logo